Table of Contents
Advertisement
Chapter 4 Troubleshooting the Installation
Having Difficulty?
I cannot connect to the Internet
Verify that the plug to your wireless home gateway AC power is properly
inserted into an electrical outlet.
Verify that your wireless home gateway AC power cord is not plugged into an
electrical outlet that is controlled by a wall switch. If a wall switch controls the
electrical outlet, make sure the switch is in the ON position.
Verify that the POWER and CABLE indicator lights on the front panel of your
wireless home gateway are illuminated.
Verify that the indicator lights on your router or other network connection
equipment are illuminated
Verify that all cables are properly connected, and that you are using the correct
cables.
Verify that your cable service is active and that it supports two-way service.
Verify that TCP/IP is properly installed and configured on all devices if you are
using the Ethernet connections.
Verify that you have followed the procedure in How Do I Install USB Drivers?, if
you are using the USB connection.
Verify that you have called your service provider and given them the serial
number and MAC address of your wireless home gateway.
If you are using a cable signal splitter so that you can connect the cable signal to
other devices, remove the splitter and reconnect the cable so that the wireless
home gateway is connected directly to the main cable input. If the wireless home
gateway now functions properly, the cable signal splitter may be defective and
may need to be replaced.
For best performance over an Ethernet connect, your PC should be equipped
with a 10/100BaseT network interface card.
52
78-4011351-01 Rev B
Advertisement
Table of Contents
Troubleshooting
