Table of Contents
Advertisement
Lubricating the Cables
If possible, grease both ends of the cables and move the controls to end stop positions when lubricating.
Refit the rubber covers on the cables after lubrication. Cables with sheaths will bind if they are not
lubricated regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it vertically. Lubricate it with thin engine oil until the oil begins to
escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hang
vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.
Lubricating in Accordance with the
Lubrication Schedule
1. Hydraulic System, Oil Level
The hydraulic oil and filter shall be replaced
every 300 hours, and at least once a year.
Contact an authorized service workshop.
Check the oil level in the hydraulic tank daily.
The level shall be about 19 - 25 mm
(3/4"-1") below the top of the tank.
Check connections, hoses, and tubes for
damage or leaks. Replace or repair if
doubtful.
Changing Oil and Filters
Oil and filter changes shall be carried out by
an authorized service workshop and are
described in the Workshop Manual.
2. Driver's Seat
Tip the seat.
Lubricate the linked mount at the front using
an oilcan.
Lubricate the lengthways adjustment
mechanism with the oilcan.
Lubricate the lengthways adjustment runners
with the oilcan.
34
English-
LUBRICATION
Checking the hydraulic oil
Lubricating the lengthways adjuster under the seat
8011-565
8011-571
Hide quick links:
Advertisement
Table of Contents
