Removing The Unit - Kenwood KDC-X589 Instruction Manual
Cd-receiver
Hide thumbs
Also See for KDC-X589:
- Instruction manual (58 pages) ,
- Service manual (44 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Removing the Unit
Removing the hard rubber frame
Removing the Unit
4
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
1
Refer to the section <Removing the hard rubber
frame> (page 36) and then remove the hard
rubber frame.
2
Remove the screw (M4 x 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
Screw (M4X8)
(commercially available)
\,
Accessory@
Removal tool
2
When the upper level is removed, remove the
lower two locations.
• The frame can be removed from the bottom side in the
same manner.
A
~
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
~
• Be careful to avoid injury from the catch pins on the
removal tool.
S
Pull the unit all the way out with your hands,
being careful not to drop
it.
·36 I
English
Hide quick links:
Advertisement
Table of Contents
