Table of Contents
Advertisement
6
Cisco Physical Access Input Module
What's In the Box
Each Cisco Input Module includes the following:
• 20 resistors (1K) for supervised input interfaces
• 2 mounting brackets, with 4 screws for each bracket
• Regulatory compliance and safety information
• Quick Start Guide
• Connector plugs:
Type
Quantity
3 Pin
1
2 Pin
13
Input Module and Port Descriptions
The Cisco Input Module includes 10 ports for connecting additional input devices, as shown in Figure 6.
Figure 6
Cisco Input Module Ports and Connectors
6
5
4
The following items are shown in Figure 6:
Type
Power
1
2
CAN interface
CAN terminator
3
Description
Two-pin connector for Voltage In (VIN) and Ground (GND) to connect a 12 to 24 VDC
external power source.
A 3-wire CAN interface used to connect the module to the CAN bus.
The CAN terminator switch should be set to ON for the last device in a CAN wiring bus.
This switch should be set to OFF for all other devices in the CAN bus.
1
2
3
13
Advertisement
Table of Contents
