Advertisement
Quick Links
Download this manual
See also:
User Manual
D-Link
DI-704 Quick Installation Guide
1. Hardware Installation
A. Setup LAN connection: connect an Ethernet cable (straight-through) from your
computer's Ethernet port to one of the LAN ports of the DI-704.
B. Setup WAN connection: connect the network cable from your cable or DSL modem
to the WAN port of the DI-704. Use the cable that came with your Cable or DSL
modem. If you don't see a link light on the WAN LED, try the other network cable.
C. Power on: connect the power cord to power inlet and turn the power switch on. The
DI-704 will automatically enter the self-test phase. When in the self-test phase, the
indicators M1 and M2 will be lit for about 5 seconds, and then M1 and M2 will flash
three times to indicate that the self-test operation has finished. Finally, the M1 will
flash continuously once per second to indicate that the DI-704 is in normal operation.
*If you are using PPPoE, begin Step 5.
If you are not using PPPoE, proceed to Step 2 below.
2. Find and Write Down Your Computer's Internet Settings
A. Open the Control Panel
B. Find and Double Click the Network Icon
Advertisement
Related Manuals for D-Link DI-704
Summary of Contents for D-Link DI-704
- Page 1 B. Setup WAN connection: connect the network cable from your cable or DSL modem to the WAN port of the DI-704. Use the cable that came with your Cable or DSL modem. If you don’t see a link light on the WAN LED, try the other network cable.
- Page 2 Click the Identification Tab Find and double click the TCP/IP setting for your Network Adapter that connects to your cable or DSL modem. If you have not yet installed your network card, install your network card, and then return to this step. You should see one of the following screens: D.
- Page 3 G. Write down whether "Obtain An IP Address Automatically" or "Specify an IP Address" is checked. H. If Specify is checked, write down the IP Address ____. ____. ____. ____ and Subnet Mask ____.____.____.____ on a sheet of paper. If Specify is checked, find and write down your Gateway address ____.____.____.____ by clicking on the Gateway tab.
- Page 4 K. If Specify was checked, find and write down your DNS Server addresses _____.____.____.____ , ____.____.____.____. There are normally two, but only one is needed. In step 4 all of this information will be required to configure the DI-704 with your provider.
- Page 5 User Manual – Chapter 4.4. settings or add the IP address of the DI-704 into the exceptions box. Type the DI- After all of the items are set, press the Save button and reboot the DI-704.
- Page 6 Help button or refer to the User Manual – Chapter 4.4. After all of the items are set, press the Save button and reboot the DI-704. You have now configured the DI-704. Refer to the User manual to review features and operation instructions that you may need for your use.