Using Audio With Localview; Enabling Audio For Onsite Use By Localview; Eagle Audio - Honeywell Rapid Eye System Administration Manual
Hide thumbs
Also See for Rapid Eye:
- Administrator's manual (294 pages) ,
- System administrator manual (264 pages) ,
- Operator's manual (150 pages)
Table of Contents
Advertisement
Configuring Other Hardware
Using Audio with LocalView
Enabling Audio for Onsite Use by LocalView
Eagle Audio
TIP!
162
At sites where LocalView is in use, Channel 2 can be reserved for use onsite. View operators
using these sites can use only Channel 1. Audio can be changed by Multi-Media System
Administrators by using View to connect to the Multi-Media unit.
1.
On the Audio Setup tab, add a checkmark to the Channel 2 (Right) Used by Site
Operator for Local Audio Monitoring checkbox. The channel 2 Enable, Record and
name fields become unavailable. They are not needed for monitoring audio by a
LocalView operator.
2.
In the Channel 1 controls, add checkmarks to the Enable boxes for Talk, Listen or
both, as needed.
3.
You have the option of adding checkmarks to Record boxes for Talk, Listen or both,
as needed. The Enable box needs to be checked before the Record box can be.
Disabling Audio for LocalView
Using either View (or LocalView), on the Audio tab, remove the checkmark from the
Channel 2 (Right) Used by Site Operator for Local Audio Monitoring checkbox.
Eagle Audio is discussed in the
800-00371. Please contact your Multi-Media distributor if you need more information about
Eagle Audio.
Note
Eagle Audio is supported on the Rapid Eye 16-channel units. Rapid Eye's 4-,
8-, and 9-channel units do not support the Eagle Audio interface.
Multi-Media Audio differs from Eagle Audio, which is an optional, third party, audio
interface.
Multi-Media and Eagle Audio Configuration Guide,
Advertisement
Table of Contents
