Section 2: Set-Up Adjustments; Beam Landing - Sony TRINITRON KV-36FS100 Service Manual
Trinitron color television, ba-5d chassis
Hide thumbs
Also See for TRINITRON KV-36FS100:
- Service manual (37 pages) ,
- Specifications (1 page) ,
- Operating instructions manual (64 pages)
Table of Contents
Advertisement
Available languages
Available languages
The following adjustments should be made when a complete
realignment is required or a new picture tube is installed.
These adjustments should be performed with rated power supply
voltage unless otherwise noted.
The controls and switch should be set as follows unless otherwise
noted:
PICTURE CONTROL: normal
BRIGHTNESS CONTROL: normal
2-1. BEAM LANDING
Preparation:
• Input a white pattern signal.
• Face the picture tube in an East or West direction to reduce the
influence of geomagnetism.
NOTE: Do not use the hand degausser; it magnetizes the CRT .
1. Input white pattern from pattern generator.
2. Loosen the deflection yoke mounting screw, and set the purity control
to the center as shown below:
Purity Control
3. Input green pattern from pattern generator.
4. Move the deflection yoke backward, and adjust with the purity control
so that green is in the center and red and blue are even on both sides.
5. Move the deflection yoke forward, and adjust so that the entire screen
becomes green.
SECTION 2: SET-UP ADJUSTMENTS
Blue
Red
Green
Perform the adjustments in order as follows:
1.
Beam Landing
2.
Convergence
3.
Focus
4.
Screen (G2)/White Balance
Test Equipment Required:
1.
Color Bar Pattern Generator
2.
Degausser
3.
DC Power Supply
4.
Digital Multimeter
5.
Oscilloscope
6.
CRT Analyzer
6. Switch over the raster signal to red and blue and confirm the
condition.
7. When the position of the deflection yoke is determined, tighten it with
the deflection yoke mounting screw.
8. When landing at the corner is not right, adjust by using the disk
magnets.
Disk magnets
or rotatable disk
magnets correct
these areas (a-d)
b
d
— 12 —
KV-36FS100/36FS200/38FS200
Purity control
corrects this area
a
b
c
d
Deflection yoke positioning
corrects these areas
a
c
- Quick Links:
- Service Manual
- Specifications
Hide quick links:
Advertisement
Chapters
Table of Contents
