Advertisement
Quick Links
Download this manual
See also:
User Manual
B roadband Pakistan
B roadband
B roadband
B roadband
ADSL Installation Guide
HUAWEI EchoLife HG-510
Pakistan
Pakistan
Pakistan
Advertisement
Related Manuals for Huawei EchoLife HG-510
Summary of Contents for Huawei EchoLife HG-510
- Page 1 B roadband B roadband Pakistan Pakistan B roadband B roadband Pakistan Pakistan ADSL Installation Guide HUAWEI EchoLife HG-510...
- Page 2 PTCL introduces DSL service for our valued subscribers. We are committed to provide you quality internet services. Please follow the installation instructions and log on to your ADSL broadband link. Step 1: Connecting to the Splitter, Power Connection & LAN cable. 1 Line hole connects to PTCL wire or Wall phone Jack (RJ-11 Jack).
- Page 3 2. Double click “internet protocol (TCP/IP)”, Check “Use the following IP address” and make the following settings: IP Address: 192.168.1.3 Subnet Mask: 255.255.255.0 Gateway: 192.168.1.1 Then, check “Use the following DNS server addresses” and make the following settings: Preferred DNS Server: 203.99.163.240 Alternate DNS Server: 203.135.0.170...
- Page 4 A small pop up window will open as shown in the figure below and ask ”User Name” and “Password” for opening the CPE’s interface. Enter User Name: “admin” and Password: “admin” and press OK. 4. Following page will be displayed after entering correct User name and Password: Page 3...
- Page 5 5. Click the Device Info link on the left hand side tabs, more options will be shown. Click Statistics and further more options will be shown, among them select ADSL. Page 4...
- Page 6 6. Clicking ADSL will show the ADSL line parameters, Note the SNR Margin and Line Attenuation. SNR must be higher than 08 dB and Line Attenuation must be less than 45 dB for establishing a stable DSL connection. 7. Select “Advanced Setup” from the left hand tabs and following window will be displayed 8.
- Page 7 10. Enter the values of VPI = 0 & VCI = 103 for copper (Note: For ONU use VPI=8 & VCI=81) and check “Enable Quality of Service” and click Next as shown under. 11. Select “PPP over Ethernet PPPoE” and click Next. 12.
- Page 8 13. Uncheck the “Enable Firewall” checkbox and click Next as shown below. Page 7...
- Page 9 14. “WAN Setup Summary” page is displayed showing the settings/configurations, click Save button to save the configurations. 15. Click Save/Reboot, a message window is shown, click OK to save the changes. Page 8...
- Page 10 16. DSL Router Reboot window is shown. Wait until the next window is shown displaying the Device Info. 17. Go again to Internet Protocol (TCP/IP) Properties and Select Obtain an IP address automatically and leave the DNS server addresses unchanged as shown in the picture below and press Ok.