Required Tools And Equipment - Cisco ASR 9000 Series Installation Manual
Aggregation services router ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Chapter 2
Installing Line Cards in the Cisco ASR 9000 Series Router
To avoid damaging card mechanical components, never carry an Route Switch Processor (RSP), modular
Caution
port adapter, or line card by the captive installation screws or ejector levers. Doing so can damage these
components and cause card insertion problems.
•
•
For safety, periodically check the resistance value of the ESD strap. The measurement should be between
Caution
1 and 10 megohms.
Required Tools and Equipment
You need the following tools and parts to remove and install line cards or modular port adapters:
•
•
•
•
If you need additional equipment, see Cisco.com or your service representative for ordering information.
Note
Place removed line cards or modular port adapters component-side-up on an antistatic surface or in
a static shielding bag. If you plan to return the component to the factory, immediately place it in a
static shielding bag.
Avoid contact between the line cards or modular port adapters and clothing. The wrist strap only
protects the board from ESD voltages on the body; ESD voltages on clothing can still cause damage.
Flat-blade or Phillips screwdriver
ESD-preventive wrist or ankle strap and instructions
Interface cables to connect the line card with another router or switch
Any SFP/XFP modules you need to install (and are not already installed)
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Preparing for Installation
2-3
Advertisement
Table of Contents
Troubleshooting
