Motion Control Levers - Toro GrandStand 74534TE Operator's Manual
Grandstand mower with 91cm or 102cm turbo force cutting unit
Hide thumbs
Also See for GrandStand 74534TE:
- Operator's manual (68 pages) ,
- Service manual (268 pages) ,
- Operator's manual (68 pages)
Table of Contents
Advertisement
G012704
1. Switch screws
2. Cam
9. After the cam is adjusted, the lever switch needs to
be checked.
10. Check the gap between the control lever and switch
as shown in Figure 71. The gap needs to be an 1/8
inch (3mm) with the right motion control lever in
the neutral, unlocked position.
11. If needed, loosen the screws holding the switch and
adjust the switch (Figure 70 and Figure 71).
1
Figure 70
3. Nut
3
2
3
1. Switch (on front side)
2. 1/8 inch (3mm)
12. Tighten the switch screws.
Adjusting the Neutral Position for the
Motion Control Levers
Important: Ensure the tracking of the mower is
correct after adjusting the motion control levers.
Adjusting the tracking and aligning the motion
control levers front to back is the same procedure
(Figure 72).
Note: Adjust the horizontal alignment before the front
to back alignment.
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required.
1. After the horizontal alignment is finished, check
the front to back alignment by slightly pushing the
control levers forward to take up any slack in the
linkage for the control levers (Figure 72).
50
G012705
Figure 71
3. Right motion control lever
in the neutral unlocked
position
1
2
2
Hide quick links:
Advertisement
Table of Contents
