Table of Contents
Advertisement
GENERAL DESCRIPTIONS
FEATURES
Digital Light Processing
P500DL is a projection unit using the Texas Instruments' Digital Mirror Device (DMD)
element.
The DLP
XGA resolution.
Flexible input capability
From Video signal (NTSC/PAL) to SXGA 75Hz are compatible.
Incoming PC signal timing should be followed the VESA standard.
XGA signal is reproduced on screen without having any scaling function.
The other frequencies are converted to XGA resolution inside the cube. See note 1.
Internal magnification
A multi-screen system can be formed easily with an internal magnification function from 1x1 to 6x6
with some popular magnification ratio as 2x3, 3x4 or 4x5.
Digital signal link between units
The unit has digital I/O interface. A signal supplied to 1
following cube with DVI digital Link Cable. Signal distributor and other signal cables are not
necessary. See Not2 below.
Superior image quality
* Native resolution of XGA, 1024x768 pixels
* No burn-in unlike projection tube
* High Contrast image by 12-degree mirror flip DMD chip
Easy installation and maintenance
* Convergence free between colors
* Steady geometric alignment
* Engine installed at factory
* Easy replacement 6000H (Survival rate of 50%) UHP 120W lamp, See note 3
Low power consumption
120W UHP lamp is used for light source.
Total power consumption is 200W.
Highly reliable control system
Projection system can be controlled with a PC via RS232C cable. Also most of the control/adjustment
is possible to do with optional wired remote control, CT-90000.
RS232C IN/OUT are to send command and also for communication between cubes.
Mechanical function
Screen escutcheon can be removed from front.
Almost all the connection cables can be hidden inside the cube.
Note 1: This does not mean that all the signals are accepted. For acceptable signals, refer to the later page in Acceptable
Signal Type and also Acceptable RGB input Signal Timing.
Note 2: Maximum number of units which can be connected via Digital Signal Link is depend on input signal quality, including
S/N and jitter, etc..
Note 3: The lamp is expected to last more than 4000H, with the recent information, it will be more than 6000H, with survival
rate of 50%, however, the actual life of each lamp varies depending on conditions of use. For warranty and exchange
of lamp, please check with your dealer/distributor.
(DLP
) by Texas Instruments
TM
TM
, Digital Light Processing
TM
engine is constructed with the DMD chip, with
TM
unit, master cube, is distributed to the
st
8
optical
TM
Advertisement
Table of Contents
