Table of Contents
Advertisement
[F] Paper-stop switch
(1) Remove the aligning unit.
(2) Remove the 2 screws and the bracket fixing
the paper stop switch.
(3) Disconnect the connector, remove the two
hooks, and then the paper-stop switch.
Note: When installing the switch bracket, install
the switch bracket so that the positional re-
lationship between the actuator and switch
is as shown in the figure on the right.
[G] Aligning unit
(1) Disconnect the connector on the rear side.
(2) Remove the developer and the cleaner, draw
out the belt transport unit, and then remove the
pin bracket (1 screw).
6570/5570 PAPER FEED SYSTEM
Aligning unit frame
Mounting switch
Connector
Belt transport unit
9 - 8
Actuator
Switch
Wheel
Mar. 1999 © TOSHIBA TEC
Hide quick links:
Advertisement
Table of Contents
