Front Drive Bezel; Removing The Front Drive Bezel; Installing The Front Drive Bezel - Dell PowerEdge T605 Systems Hardware Owner's Manual
Hide thumbs
Also See for PowerEdge T605 Systems:
- Getting started with (129 pages) ,
- Getting started manual (59 pages) ,
- Manual (26 pages)
Table of Contents
Advertisement
9
control panel
11
5.25" drive bay
13
front drive bezel
15
3.5" hard drives
17
system memory
Front Drive Bezel
The front drive bezel is the cover for the optional optical drive, floppy drive,
tape drive, or hot-plug hard drives (when available). To remove or install any
of these drives, you must first remove the front drive bezel.
NOTE:
If you are removing or installing a hot-plug hard drive (when available), the
system may remain turned on and in the upright position when removing the front
drive bezel (see "Removing a Hot-plug Hard Drive" on page 88). If you plan to remove
or install any other system components, the system should be in the orientation
shown in Figure 3-1 (see "Opening the System" on page 68).
Removing the Front Drive Bezel
1 Using the system key, unlock the bezel.
2 Slide the lever in the direction of the arrow until it releases the bezel from
the top of the chassis (see Figure 3-2).
3 Rotate the top end of the bezel away from the chassis, and lift the bezel
out from the chassis, removing the bezel tabs from the slots as shown in
Figure 3-2.
Installing the Front Drive Bezel
1 Insert the bezel tabs into the bezel tab slots in the chassis (see Figure 3-2).
2 Firmly press the top end of the bezel into the chassis until the lever locks
into place.
3 Using the system key, lock the bezel.
66
Installing System Components
10
optical disk drive
12
3.5" floppy drive
14
expansion card fan
16
system board
Advertisement
Table of Contents
Troubleshooting
