1. Precautions 1. Precautions 1-1. Safety Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1-1. Warnings For continued safety, do not attempt to modify the circuit board. Disconnect the AC power and DC power jack before servicing.
1. Precautions 1-2. Servicing Precautions WARNING: An electrolytic capacitor installed with the wrong polarity might explode. Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual. Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.
1. Precautions 1-4. Installation Precautions For safety reasons, more than two people are required for carrying the product. Keep the power cord away from any heat emitting devices, as a melted covering may cause fire or electric shock. Do not place the product in areas with poor ventilation such as a bookshelf or closet. The increased internal temperature may cause fire.
2. Product specifications 2-2. Spec Comparison to the Old Models Model P2250W P2050(G) / P2250(G) / P2350(G) Design 1600x900 (P2050) Resolution 1680 x 1050 1920x1080 (P2250/P2350) Input Analog / DVI Digital Analog / DVI Digital Response Time Viewing Angle 170/160(CR>10) 170/160(CR>10) Brightness 300cd/m²...
Quick Setup Guide BN68-01925C Warranty Card BN68-00226R (Not available in all locations) User’s Guide, Monitor Driver, BN96-10917A Natural Color Pro Software Stand Body BN96-10575A Samsung Electronics Service center Stand Base BN96-09629A D-sub Cable BN39-00244G 1,500mm(1.5M) Power Cord 3903-000452 1,830mm(1.8M) Cleaning Cloth...
Page 41
6. Wiring Diagram Block Role Description Remarks Scaler The ADC, TMDS, Scaling and Controller are integrated on a SE758MRH IC200 single chip. FLASH MEMORY Stores the firmware for the Scaler. The information can be IC201 updated. EEPROM NVRAM Stores the OSD, Timing etc. IC203 24C08 EEPROM...
6. Wiring Diagram 6-2. Wiring Diagram - IP Board LVDS Connector (Connect to Panel) IP board 3711-003847 3708-001150 Scaler SE758MRH 3701-001173 3701-001219 Function Connector (Connect to IP-Board) RGB Connector DVI Connector (Connect to PC) (Connect to PC)
6. Wiring Diagram 6-3. Connector Functions Connector Functions CN600 Supplies 5V from the power board to the main board and transmits the PWM output from the power board to the inverter. *When a problem occurs: The No Power and Blank Screen errors may occur. CN1 ~ CN4 In Transmits the lamp current (6mA ~ 7mA) generated in the inverter to the lamp of the panel.