hit counter script

Olson Technology OTPN-3850-SA Instruction Manual

Olson 3.85ghz wideband ftth pon receiver

Advertisement

Quick Links

Table of Contents
Model OTPN-3850-SA
3.85GHz Wideband FTTH PON Receiver
Instruction Manual
Phone: (209) 586-1022
(800) 545-1022
FAX:
(209) 586-1026
E-Mail:salessupport@olsontech.com
025-000641 REV X5
06 Sep 2012
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Olson Technology OTPN-3850-SA

  • Page 1 Table of Contents Model OTPN-3850-SA 3.85GHz Wideband FTTH PON Receiver Instruction Manual Phone: (209) 586-1022 (800) 545-1022 FAX: (209) 586-1026 E-Mail:salessupport@olsontech.com 025-000641 REV X5 06 Sep 2012 Page 1...
  • Page 2: Table Of Contents

    ACCESSORIES AND SYSTEM APPLICATIONS ....... . 025-000641 REV X5 Olson Technology, Inc. Page 2...
  • Page 3: Introduction

    The signal is then amplified and output to a single “F” connector output. The OTPN-3850-SA Integrated PON Receiver dimensions are 1.05" H x 3.15" W x 4.75" L. Optical connections are via two SC/APC connectors, one for the optical input carrying 1310nm, 1490nm &...
  • Page 4: Block Diagram

    BLOCK DIAGRAM Olson Technology OTPN-3850-SA 3.85GHz Wideband FTTH PON Receiver Optical 1310, 1490, 1550nm Light Level Optical Level Level 1550nm Optical In Detect Photodiode FWDM Optical Out 1310 & 1490nm Optical Alarm Amplifier (-10dBm) Control Circuitry Alarm 50-3,850 MHZ Attenuator Control Voltage...
  • Page 5: Installation / Environmental Considerations

    If mounting with a machine screw (to tapped holes), use 4-40 pan-head screws. Figure 1 shows the dimensions of the bottom plate of the OTPN-3850. FIGURE 1 - OTPN-3850 MOUNTING PLATE 025-000641 REV X5 Olson Technology, Inc. Page 5...
  • Page 6: Optical Connectors And Cleaning

    Pin 8 Ground (Black on OTPS-12A-10M) Pin 9 (No wire on OTPS-12A-10M) Pin 10 (No wire on OTPS-12A-10M) Olson OTPS-12A-10M (Sold separately) is recommended for use with the OTPN-3850. FIGURE 2 - Electrical Connector Pin Configuration 025-000641 REV X5 Olson Technology, Inc. Page 6...
  • Page 7: Setup And Operation

    Now return to the L-Band transmitter and adjust the RF drive level so that the L-Band channels are about +13dBmV or less. FIGURE 3 - Optical Monitor Output Voltage vs. Input Light Level 025-000641 REV X5 Olson Technology, Inc. Page 7...
  • Page 8: Accessories And System Applications

    Ethernet Equipment Note: For simplicity, the hardware associated with the Ethernet Signals usually associated with this type of system are not fully shown. FIGURE 4 - Typical System Application Using the OTPN-3850 025-000641 REV X5 Olson Technology, Inc. Page 8...

Table of Contents