Step 5: Install The Mounting Plate - LG LMV1314W Installation Instructions Manual
Hide thumbs
Also See for LMV1314W:
- Owner's manual (27 pages) ,
- Service manual (45 pages) ,
- Owner's manual (52 pages)
Table of Contents
Advertisement
STEP 5:
INSTALL THE MOUNTING PLATE
1. Remove the template from upper cabinet.
NOTE: If you are venting the oven through the
wall,
be sure you align the duct connector
(included) on the rear of the mounting
plate with the 3
See Figure 21, 22.
2. If you have drywall, Prepare the toggle bolts
(not included) by putting the bolts through
the corner holes and attaching a spring toggle
head to the end of each toggle bolt as shown in
Figure 23.
3. Place the mounting plate against the wall and
match the screw holes. See Figure 23.
NOTE: Be sure to leave at least one wall-
thickness of space between the head of
the toggle bolt
and the spring toggle head so that the
spring toggle can open on the inside of
the wall, as shown in Figure 25.
You may have to pull out slightly on the
bracket to put tension on the toggles.
4. Locate the stud holes (3/16") and insert the lag
screws through the mounting plate and into the
holes.
See Figure 26.
5. Insert the toggle bolts through the drywall holes
(3/4"). Tighten the toggle bolts.
toggle bolt
mounting plate
1 /4
"x10" duct.
spring
wall
toggle head
Figure 25
mounting plate
toggle bolt
lag screw
Figure 26
- 14 -
Figure 21
Figure 22
spring
toggle head
mounting plate
Figure 23
support tabs
Figure 24
mounting pate
Hide quick links:
Advertisement
Table of Contents
