Table of Contents
Advertisement
Adjusting Projected Images
• Corner Wall
Manually correct distortion that occurs when projecting on a surface with
right angles, such as a square pillar or the corner of a room, and adjust
the amount of expansion and contraction.
"Corner Wall"
p.63
s
a
• By pressing the [
the selected adjustment method directly.
• You cannot combine multiple adjustment methods. However, you
can use Point Correction after performing Curved Surface or Corner
Wall.
• To make sure that keystone correction is performed correctly, set the
Lens Type in the Configuration menu according to the lens you are
using.
s Extended - Operation - Lens Type
H/V-Keystone
Manually correct distortion in the horizontal and vertical directions
independently. Distortion can be corrected when the angle of vertical and
horizontal tilt of the projector is up to 30 degrees (19 degrees when using
the short throw zoom lens ELPLU01) against the screen.
a
Press the [Menu] button while projecting.
b
Select Geometric Correction from Settings.
] button on the control panel, you can perform
p.112
c
Select H/V-Keystone, and then press the [
If the message "If this setting is changed, the image may be
distorted." is displayed, press the [
d
Use the [
][
] buttons to select the correction method, and
then use the [ ][ ] buttons to make the corrections.
V-Keystone
H-Keystone
a
When you correct keystone distortion, the projected image may
be reduced.
e
To complete the corrections, press the [Menu] button.
52
] button.
] button.
Advertisement
Table of Contents
