Installing Or Replacing Server Components - Cisco UCS C220 M4 Installation And Service Manual
Hide thumbs
Also See for UCS C220 M4:
- Maintaining the server (72 pages) ,
- Quick start manual (29 pages) ,
- Service note (10 pages)
Table of Contents
Advertisement
Installing or Replacing Server Components
Installing or Replacing Server Components
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Caution
When handling server components, wear an ESD strap to avoid damage.
You can press the unit identification button on the front panel or rear panel to turn on a flashing unit
Tip
identification LED on the front and rear panels of the server. This button allows you to locate the specific
server that you are servicing when you go to the opposite side of the rack. You can also activate these
LEDs remotely by using the Cisco IMC interface. See the
page 3-2
This section describes how to install and replace server components, and it includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco UCS C220 M4 Server Installation and Service Guide
3-10
for locations of these LEDs.
Replaceable Component Locations, page 3-11
Replacing Hard Drives or Solid State Drives, page 3-12
Replacing Fan Modules, page 3-14
Replacing the Motherboard RTC Battery, page 3-16
Replacing DIMMs, page 3-18
Replacing CPUs and Heatsinks, page 3-22
Replacing an Internal SD Card, page 3-26
Enabling or Disabling the Internal USB Port, page 3-27
Replacing a Cisco Modular RAID Controller Riser (Internal Riser 3), page 3-27
Replacing a Cisco Modular RAID Controller Card, page 3-29
Replacing a Modular RAID Controller Transportable Memory Module (TMM), page 3-30
Replacing the Supercap Power Module (RAID Backup), page 3-33
Replacing a Software RAID 5 Key Module, page 3-34
Replacing a PCIe Riser Assembly, page 3-36
Replacing a PCIe Card, page 3-38
Installing and Enabling a Trusted Platform Module, page 3-45
Replacing an mLOM Card, page 3-48
Replacing Power Supplies, page 3-50
Chapter 3
Maintaining the Server
"Status LEDs and Buttons" section on
OL-32473-01
- Quick Links:
- Initial Server Setup
Hide quick links:
Advertisement
Table of Contents
