Cisco UCS C220 M4 Installation And Service Manual page 58
Hide thumbs
Also See for UCS C220 M4:
- Maintaining the server (72 pages) ,
- Quick start manual (29 pages) ,
- Service note (10 pages)
Table of Contents
Advertisement
Installing or Replacing Server Components
Table 3-4
DIMM Mixing Rules for C220 M4 Servers
DIMM Parameter
DIMM Capacity:
RDIMM = 8 or 16 GB
LRDIMM = 32 or 64 GB
DIMM Speed:
2133 or 2400 MHz
DIMM Type:
RDIMMs or LRDIMMs
Memory Mirroring and RAS
The Intel E5-2600 CPUs within the server support memory mirroring only when an even number of
channels are populated with DIMMs. If one or three channels are populated with DIMMs, memory
mirroring is automatically disabled. Furthermore, if memory mirroring is used, DRAM size is reduced
by 50 percent for reasons of reliability.
For details on populating recommended memory mirroring configurations, see the specification sheet for
the server:
•
•
Lockstep Channel Mode
When you enable lockstep channel mode, each memory access is a 128-bit data access that spans four
channels.
Lockstep channel mode requires that all four memory channels on a CPU must be populated identically
with regard to size and organization. DIMM socket populations within a channel (for example, A1, A2,
A3) do not have to be identical but the same DIMM slot location across all four channels must be
populated the same.
For example, DIMMs in sockets A1, B1, C1, and D1 must be identical. DIMMs in sockets A2, B2, C2,
and D2 must be identical. However, the A1-B1-C1-D1 DIMMs do not have to be identical with the
A2-B2-C2-D2 DIMMs.
Cisco UCS C220 M4 Server Installation and Service Guide
3-20
DIMMs in the Same Channel
•
You can mix different capacity
DIMMs in the same channel (for
example, A1, A2, A3).
You can mix speeds, but DIMMs will run at
the speed of the slowest DIMMs/CPUs
installed in the channel.
You cannot mix DIMM types in a channel. You cannot mix DIMM types in a bank.
Cisco UCS C220 M4 High Density Rack Server (Small Form-Factor Disk Drive Model)
Specification Sheet
Cisco UCS C220 M4 High Density Rack Server (Large Form-Factor Disk Drive Model)
Specification Sheet
Chapter 3
Maintaining the Server
DIMMs in the Same Bank
•
You can mix different capacity DIMMs
in the same bank. However, for optimal
performance DIMMs in the same bank
(for example, A1, B1, C1, D1) should
have the same capacity.
You can mix speeds, but DIMMs will run at
the speed of the slowest DIMMs/CPUs
installed in the bank.
OL-32473-01
- Quick Links:
- Initial Server Setup
Hide quick links:
Advertisement
Table of Contents
