Mechanical Operation; Cd Mechanism Normal Operation - Sony DVP-NS300 Training Manual

Circuit descriptions & troubleshooting

Hide thumbs Also See for DVP-NS300:

Table of Contents

1. Remove the top cover, unplug black connector CN807 (power ON to micro) and lay the top panel on the side.

Do not shear or disconnect the white ribbon connector (CN814 to CN005).

2. Plug the unit into AC and press the power ON button. The unit will not power ON until the micro receives the

power ON via CN807.

3. On the front panel circuit board as shown in Figure 8-2, jump CN807. The unit should power up and show

the model number in the display followed by "Ready".

The disc entry is detected either by a photodetector or by Switch SW-11 closing. The loading motor starts and

turns rollers to pull the disc in. The remaining switches on top, SW-11 to 18, shown in Figure 8-3 and Table 8-1,

determine the position of the disc and its size to the microprocessor. The disc enters, overshoots the center and

returns to center (loading motor reverses) so SW-14 momentarily opens. Figure 8-4 lists the switch positions

during loading and Disc IN. O = Open, C = Closed, M = Momentarily.

FIGURE 8-2 - COVER OFF / POWER ON

FIGURE 8-3 - CD MECH - TOP VIEW

CN807

plug &

socket

Photodetector

SW-11

8. Mechanical Operation

Front

Table of Contents

Show Quick Links

Table of Contents

Dvp-nc650 Dvp-nc655p Dvp-ns400d Dvp-cx875p Dvp-ns415 Dvp-f25 ... Show all