Mounting Of Indoor Unit - LG LA090HVP Installation Manual

Single zone art cool gallery wall mount single zone art cool gallery wall mounted

Hide thumbs

Table Of Contents

Table of Contents

Mounting Indoor Unit

Refer to Figure 10 as you mount the indoor unit.

Procedure

1. Using the supplied mounting template, align and level the tem-

plate onto the wall.

Be careful to not discard or accidentally throw out the mounting template

that comes with the unit. This template assures accurate measurements

when drilling the holes for attaching screws.

2. Lightly attach the guide using adhesive tape.

3. Using a drill, create four 1/4 inch holes which are approximately 1

1/4 inch deep at the drill and cross marks on the mounting guide.

4. Using the four plastic anchors, drive each one into each of the

drilled holes.

Plastic anchors

5. Insert screws into the top left and right of the guide and leave

about 1/3 inch of the screw out of the wall.

• This will allow enough room to hang the Gallery unit.

Hanger hole

(Rear side of

the product)

9. Check the xed product with light powe

GENERAL INSTALLATION GUIDELINES

I N S

T A

I I A

T I O

N G

U I D

E M

I N

S T

A L

L A

T I O

N G

U I D

E M

A P

IN S T

A L L A

T IO N

G U ID

E M A

Due to our policy of continuous product innovation, some specifications may change without notification.

Figure 10: Gallery Indoor Unit Components

Signal Receptor

Front Panel

ON/OFF butto n

Air Discharge

Select location carefully. Unit should be anchored to a strong wall to pre-

vent unnecessary vibration.

• When choosing a location for the wall mount plate, be sure to take

into consideration routing of wiring for power outlets within the wall.

Contacting wiring can cause serious bodily injury or death.

• Use caution when drilling holes through the walls for the purposes

of piping connections. Power wiring can cause serious bodily injury

or death.

6. Once the top is attached, anchor the bottom of the Gallery unit

using the plastic anchors and screws. Also leave about 1/3 inch

of the screw out of the wall to hang the unit.

completely the upper screws.

7. Once unit is anchored, test by gently applying downward

pressure with both hands and jiggling to be sure it is securely

attached.

• If it is loose in anyway, retrace the above steps and adjust any of

the screws as needed.