Table of Contents
Advertisement
Control, Clock and Timer
The clock must be set for the
automatic oven timing functions to
work properly. The ti~e of day
cannot be changed during a Time
Bake or Clean cycle.
To Set the Clock
Quick Set-Clock
1. Press CLOCK pad.
2. Press INCREASE or
DECREASE pad to enter
the time.
Step 1. Touch the CLOCK pad.
Step
2. P1ess INCREASE or
DECREASE pad to set the time
The clock start~ lmmedlately,
the words SET TIME go off aftel
Power Outage?
After a power outage, when power
is restored the display will flash
and time shown will no longer be
correct—for example, after a 5-
minute power interruption the
clock will be 5 minutes slow.
All other functions that were in
operation when the power went out
will have to be programmed again.
Timer
The timer does not control oven
operations. The tnaximum setting
on the timer is 9 hours and 55
minutes.
To
Set the Timer
Step 1. Touch the TIMER
ON/OFF pad.
Step 2. Press INCREASE or
DECREASE pad to set the amount
of time on timer.
The timer will start automatically
within a few seconds of
releasing the INCREASE or
DECREASE pad.
The timer will display hours and
minutes as it counts down until the
last minute is displayed, then it
displays seconds.
T o
R e s e t T i m e r
If "TIMER" is showing, hold or
tap INCREASE or DECREASE
pad until desired time is reached. If
"TIMER" is not showing, touch
TIMER ON/OFF pad first.
To
Cancel Timer
Touch TIMER ON/OFF pad twice
to cancel if "SET TIMER" shows
on display. Touch TIMER
ON/OFF pad once to cancel if
timer has started counting down.
Timer Tones
The timer tone is a series of three
beeps followed by one beep every
six seconds. If you would like to
remove the signal that beeps every
six seconds, press CLEAWOFF
pad for 10 seconds.
To return the signal that beeps every
six seconds, press CLEAWOFF pad
for 10 seconds.
Display Messages
If "door" appears on the display,
LOCK flashes and oven signals,
you set the self-clean cycle and did
not shut the oven door.
If "F" and a number flash on
display, this indicates function
error code. Touch CLEAWOFF
pad. If function error code does not
clear, disconnect power to the oven
and call for service.
INCREASE &
DECREASE Pad Speed
You can change the speed of these
pads in 5 increments. While the
oven is off and the time of day
shows in the display, press the
INCREASE and DECREASE
pads and the TIMER pad for 2 or 3
seconds. A number from 1 to 5
will replace "0:00" in the display.
1 is slowest and 5 is fastest. Use
INCREASE or DECREASE pad to
change, then press CLEAWOFF to
return to time of day display.
7
Advertisement
Table of Contents
