Table of Contents
Advertisement
Chapter 3
Maintaining the System
Install a server node:
Step 4
a.
Note
b.
c.
Replace power cords and then power on the system by pressing and holding the power button on the front
Step 5
handle for four seconds.
Step 6
Continue with
Figure 3-26
1
Enabling TPM Support in the BIOS
After hardware installation, you must enable TPM support in the BIOS:
Note
Enable TPM support:
Step 1
a.
OL-32062-01
With the two ejector levers open, align the new server node with the empty bay.
The server node must be in the top bay, as shown in
Push the server node into the bay until it engages with the midplane connectors and is flush with the
chassis.
Rotate both ejector levers toward the center until they lay flat and their latches lock into the rear of
the server node.
Enabling TPM Support in the BIOS, page
TPM Socket Location on the Server Node Board
1
TPM socket and screw hole on motherboard
Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
Installing or Replacing System Components
Figure 1-2 on page
3-45.
Cisco UCS C3160 Rack Server Installation and Service Guide
1-2.
3-45
Advertisement
Table of Contents
