Configuring Dynamic Routing - Cisco RV180 Administrator's Manual
Hide thumbs
Also See for RV180:
- Administration manual (187 pages) ,
- Manual (14 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Configuring Networking
Configuring Routing
STEP 10
STEP 11
NOTE
STEP 1
STEP 2
STEP 3
Cisco RV180/RV180W Administration Guide
address. If you have another router handling your network's Internet connection,
enter the IP address of that router instead.
In the Metric field, enter a value between 2 and 15 to define the priority of the
route. If multiple routes to the same destination exist, the route with the lowest
metric is chosen.
Click Save.
Configuring Dynamic Routing
RIP (Routing Information Protocol, RFC 2453) is an Interior Gateway Protocol (IGP)
that is commonly used in internal networks. It allows the Cisco RV180/RV180W to
exchange its routing information automatically with other routers, and allows it to
dynamically adjust its routing tables and adapt to changes in the network.
RIP is disabled by default on the Cisco RV180/RV180W.
To configure dynamic routing:
Choose Networking > Routing > Dynamic Routing.
To configure how the router sends and receives RIP packets, choose the RIP
direction:
•
None—The router neither broadcasts its route table nor does it accept any
RIP packets from other routers. This option disables RIP.
•
In Only—The router accepts RIP information from other router, but does not
broadcast its routing table.
•
Out Only—The router broadcasts its routing table periodically but does not
accept RIP information from other routers.
•
Both—The router both broadcasts its routing table and also processes RIP
information received from other routers.
Choose the RIP version:
•
Disabled.
•
RIP-1—This is a class-based routing version that does not include subnet
information. RIP-1 is the most commonly supported version.
2
46
Advertisement
Table of Contents
