Related Manuals for GE AVS06
Summary of Contents for GE AVS06
-
Page 1: Table Of Contents
Model and Serial Numbers 2,5 Appliance Registration Problem Solver Repair Service Care and Cleaning Condenser Coils Safety Instructions Control Settings User Maintenance Instructions 5 Electrical Requirements Warranty Back Cover Energy Saver Switch Energy-Saving Tips Extension Cords Grille and Cabinet Model AVS06... -
Page 2: Appliance Registration
See grounding Consumer Affairs numbers here: instructions on page 9. GE Appliances Appliance Park Never m@ugyourair conditioner Louisville, KY 40225 by pulling on the power cord. Serial Number straight out from the receptacle. -
Page 3: Control Settings
COOL Ventilation Control When you turn the Thermostat When this control is turned to the OFF turns air conditioner off. Control to the desired setting, the CLOSED position, only the air operation thermostat will automatically control inside the room can be circulated without cooling. -
Page 4: Air Direction
To adjust air direction For normal cooliW For quieter operation 1. Set the Selector Switch at HIGH 1. Set the Selector Switch at LOW “--~- COOL. COOL position. 2. Set the Thermostat Control at 2. Turn the Thermostat Control to the desired number (usually 5-7 is the desired number. -
Page 5: Air Filter
Vacuum the filter on the dusty side to be steam cleaned, a service the clamps on the frame. to remove light dust. Wash the filter, available through your GE service cleaner side up, under gentiy flowing To replace the grille, lineup the outlet. -
Page 6: Problem Solver
Moisture removed from indoor air drains to rear of cabinet (ON OUTDOOR SIDE) where it is picked up by a fan ring and thrown against the outdoor condenser coil. If you need more help.. call, toll free: GE Answer Center” consumer information service... -
Page 7: Energy-Saving Tips
Manager, Consumer Relations . Keep windows and doors GE Appliances closed. Cool, dry air escapes Appliance Rrk when they’re open. Louisville, Kentucky 40225 Keep furnace floor registers and FINALLY, if your problem is still cold air returns closed. -
Page 8: Installation Instructions
Window Requirement This air conditioner is factory- Blade-type screwdriver prepared for installation in standard Rule or tape measure double-hung windows with Level actual opening width of 22%” Pencil to 39!’ clear, vertical opening of 123A” Screws firnished for minimum from bottom of sash This Instillation to stool. -
Page 9: Adapter Plug
Electrical Safety— Use of etiension cords Use of adapter plug not recommended IMPORTANT... Because of potential safety hazards under certain conditions, Please Read Carefully. Because of potential safety we strongly recommend against hazards under certain conditions, the use of an adapter plug. we strongly recommend against How to connect electricity However, if you still elect to use an... - Page 10 (continued) Mounting Hole B 1. Open window. Locate and mark Window Stool centerline of window. 2. Screw leveling bolt in correct Window Sill 3/8” threaded hold of support channel. Depth of window sill will Locating Hole A determine which 3/8” threaded hole to use.
- Page 11 7. Close window until it touches behind air conditioner top bar. Plastic Foam Seal , ,~ Upper Window Sash Slide filler panels outward until they touch window sash tracks. (Do not release grip on air conditioner until lower window sash is in final position.) 8.
-
Page 12: Warranty
To know what your legal rights are in your state, consult your local or state consumer affairs office or your state’s Attorney General. Warrantor: General Electric Company If further help is needed concerning this warranty, write: Manager—Consumer Affairs, GE Appliances, Louisville, KY 40225 Pub. 49-7226...