Table of Contents
Advertisement
10.1.6 ADC (Analog to Digital Converter)
This displays the value of each ADC.
1) MVBAT ADC : Main Voltage Battery ADC
2) AUX ADC : Auxiliary ADC
3) TEMPER ADC : Temperature ADC
10.1.7 BATTERY
1) Bat Cal : This displays the value of Battery Calibration. The following menus are displayed in order :
BAT_LEV_3V, BAT_LEV_2_LIMIT, BAT_LEV_1_LIMIT, , BAT_IDLE_LI MIT &
BAT_INCALL_LIMIT, SHUT_DOWN_VOLTAGE, BAT_RECHARGE_LMT
2) TEMP Cal : This displays the value of Temperature Calibration. The following menus are displayed
in order : TEMP_LOW_LIMIT , TEMP_LOW_RECHARGE_LMT, TEMP_HIGH_RECHARGE_LMT,
TEMP_HIGH_LIMIT
10.1.8 Audio
This is NOT a necessary menu to be used by neither engineers nor users.
10.1.8 DAI (Digital Audio Interface)
This menu is to set the Digital Audio Interface Mode for Speech Transcoder and Acoustic testing.
1) DAI AUDIO : DAI audio mode
2) DAI UPLINK : Speech encoder test
3) DAI DOWNLINK : Speech decoder test
4) DAI OFF : DAI mode off
10.2 RF Test [MENU 2]
10.2.1 SAR test
This menu is to test the Specific Absorption Rate.
1) SAR test on : Phone continuously process TX only. Call-setup equipment is not required.
2) SAR test off : TX process off
10.2.2 Change frequency band
This menu is to test the Specific frequency band.
1) GSM only
2) DCS only
3) PCS only
4) 850 only
5) Default
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
10. ENGINEERING MODE
- 103 -
LGE Internal Use Only
Advertisement
Table of Contents
