Table of Contents
Advertisement
RX-34
Service Software Instructions
5. Wait until you are notified that update has been successful; the procedure will take a couple of minutes.
Click OK to close the
6. If you are using the FPS-10 flash prommer, check that it is detected from the progress info. Check also the
status leds in the FPS-10. The MODE2 led (green), VBAT and POWER leds (red) should be lit. If you are using
LAN connection, the LAN led (yellow) should be blinking.
7. Check that your FPS-10 flash prommer has enough memory. Flashing the SU-18 with FPS-10 needs at least
128 MB of SRAM memory in the prommer.
Issue 2
Update Done window.
Figure 33 Prommer SW update finished
Figure 34 Prommer maintenance window
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
Page 3 –25
Advertisement
Chapters
Table of Contents
Troubleshooting
