Table of Contents
Advertisement
Electrical System
Maintenance
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Charging the Battery
Removing the Battery
WARNING
Battery terminals or metal tools could short against
metal machine components causing sparks. Sparks
can cause the battery gasses to explode, resulting
in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Raise the seat to access the battery.
4. Disconnect the negative (black) ground cable from the
battery post (Figure 46). Retain all fasteners.
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
5. Slide the rubber cover up the positive (red) cable.
Disconnect the positive (red) cable from the battery
post (Figure 46). Retain all fasteners.
6. Remove the battery hold-down (Figure 46) and lift the
battery from the battery tray.
2
3
4
1. Battery
2. Positive battery post
3. Bolt, washer, and nut
4. Terminal boot
Charging the Battery
Service Interval: Before storage—Charge the battery and
disconnect battery cables.
1. Remove the battery from the chassis; refer to Removing
the Battery.
2. Charge the battery for a minimum of 1 hour at 6 to 10
amps. Do not overcharge the battery.
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (Figure 47).
37
6
5
1
7
G005072
Figure 46
5. Negative battery post
6. Wing nut, washer, and bolt
7. Battery hold-down
- Quick Links:
- Mower Belt Maintenance
- Troubleshooting
- Schematics
Hide quick links:
Advertisement
Table of Contents
