Table of Contents
Advertisement
Engaging the Blade Control Switch
(PTO)
Note: Engaging the blade control switch (PTO) with
the throttle position at half or less will cause excessive
wear to the drive belts.
Figure 12
Disengaging the Blade Control Switch
(PTO)
Figure 13
Operating the Throttle
The throttle control can be moved between Fast and
Slow positions (Figure 14).
Always use the fast position when turning on the
mower deck with the blade control switch (PTO).
Figure 14
Operating the Choke
Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the
engine.
G008945
G009174
G008946
17
2. Pull up on the choke knob to engage the choke
before using the ignition switch (Figure 15).
3. Push down on the choke to disengage the choke
after the engine has started (Figure 15).
1
2
Figure 15
1. On
Operating the Ignition Switch
1. Turn the ignition key to the Start position
(Figure 16). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
G008959
2. Off
Advertisement
Table of Contents
