hit counter script

Adjusting The Height Of Cut - Toro 30604 Operator's Manual

Rotary mower
Hide thumbs Also See for 30604:
Table of Contents

Advertisement

Lowering the ROPS
Important: Lower the roll bar only when absolutely
necessary.
Important: Ensure that the seat is secured with the seat
latch.
Figure 12
Raising the ROPS
Figure 13

Adjusting the Height of Cut

Center Mower Deck
The height of cut is adjustable from 25 to 127 mm (1 to 5
inches) in 13 mm (1/2 inch) increments. To adjust the height
of cut on the center mower deck, position the castor wheel
axles in the upper or lower holes of the castor forks, add or
remove an equal number of spacers from the castor forks,
and secure the rear chain to the desired hole.
1. Start the engine and raise the mower decks to change
height of cut.
2. Shut off the engine and remove the key after the mower
deck is raised.
3. Position the caster-wheel axles in the same holes in all
caster forks.
1. Tensioning cap
2. Spacers
3. Shims
Note: When operating in 64 mm (2-1/2 inch) height
of cut or higher, install the axle bolt in the lower
caster-fork hole to prevent grass buildup between the
wheel and the fork. When operating at heights of cuts
lower than 64 mm (2-1/2 inches) and grass buildup is
detected, reverse the machines direction to pull any
clippings away from the wheel/fork area.
4. Remove the tensioning cap from the spindle shaft and
slide the spindle out of the caster arm
5. Install 2 shims onto the spindle shaft as they were
originally installed.
Note: These shims require a level across the entire
width of the mower decks. Slide the appropriate
number of 13 mm (1/2 inch) spacers (refer to the chart
below) onto the spindle shaft to attain the desired
height of cut; then slide the washer onto the shaft.
Refer to the following chart to determine the
combinations of spacers for the setting
23
Figure 14
4. Top axle-mounting hole
5. Caster wheel
(Figure
(Figure
14).
15):

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 410030608Groundsmaster 400030605

Table of Contents