hit counter script

Checking The Rear-Axle Lubricant; Checking The Rear-Axle-Gearbox Lubricant; Changing The Rear-Axle Lubricant - Toro 30604 Operator's Manual

Rotary mower
Hide thumbs Also See for 30604:
Table of Contents

Advertisement

6. Through the open hole, slowly fill the planetary with
0.65 L (22 oz) of high quality SAE 85W-140 wt gear
lube.
Important: If the planetary fills before the 0.65 L
(22 oz) of oil is added, wait 1 hour or install the
plug and move the machine approximately 10 feet
to distribute the oil through the brake system.
Then, remove the plug and add the remaining oil.
7. Install the plug.
8. Repeat the procedure on the opposite planetary/brake
assembly.
Checking the Rear-Axle
Lubricant
Service Interval: Every 400 hours
The rear axle is filled with SAE 85W-140 gear lube. Check
the lubricant level before you first start the engine and every
400 hours thereafter. The capacity is 2.4 L (80 oz). Visually
inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from one end of the axle and
ensure that the lubricant is up to the bottom of the
hole
(Figure
60).
Note: If the level is low, remove the fill plug and add
enough lubricant to bring the level up to the bottom of
the check-plug holes.
1. Check plug
Checking the
Rear-Axle-Gearbox Lubricant
Service Interval: Every 400 hours
The gearbox is filled with SAE 85W-140 gear lube. The
capacity is 0.5 L (16 oz). Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side of the
gearbox and ensure that lubricant is up to the bottom
of the hole
(Figure
Figure 60
2. Fill plug
61).
Note: If the level is low, add enough lubricant to bring
the level up to the bottom of the hole.
1. Gearbox
Changing the Rear-Axle
Lubricant
Service Interval: After the first 200 hours
Every 800 hours
Change the lubricant initially after the first 200 hours of
operation and every 800 hours of operation thereafter.
1. Position the machine on a level surface.
2. Clean the area around the 3 drain plugs; 1 on each end
and 1 in the center
3. Remove the check plugs to ease in the draining of the
oil.
4. Remove the drain plugs and allow the oil to drain into
the pans.
1. Drain-plug location
5. Clean the area around the drain plug at the bottom of
the gearbox
(Figure
47
Figure 61
2. Check/fill plug
(Figure
62).
Figure 62
63).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 410030608Groundsmaster 400030605

Table of Contents