Assembling And Adjustments; General; Checking The Spindle Shaft And Flange Washers; Checking The Arbor Bushing - Husqvarna K 1270 Operator's Manual
Hide thumbs
Also See for K 1270:
- Operator's manual (136 pages) ,
- Workshop manual (84 pages) ,
- Operator's manual (171 pages)
Table of Contents
Advertisement
Available languages
Available languages
General
WARNING! The engine should be
!
switched off, and the stop switch in
STOP position.
Husqvarna's blades are high speed blades approved for
hand held power cutters.
Checking the spindle shaft and
flange washers
When the blade is replaced with a new one, check the
flange washers and the spindle shaft.
•
Check that the threads on the spindle shaft are
undamaged.
•
Check that the contact surfaces on the blade and the
flange washers are undamaged, of the correct
dimension, clean, and that they run properly on the
spindle shaft.
Use only flange washers supplied by Husqvarna, min.
diameter 105 mm/4.1".
Do not use warped, notched, indented or dirty flange
washers. Do not use different dimensions of flange
washers.
Checking the arbor bushing
The arbor bushings are used to fit the machine to the
centre hole in the cutting blade.
The machine is supplied with either a bushing that can be
flipped over to fit blades with either 20 mm or 1" (25,4 mm)
centre holes, or with a fixed bushing. A decal on the blade
guard indicates which bushing has been factory fitted
together with appropriate blade specification.
•
Check that the bushing on the machine's spindle shaft
corresponds with the centre hole of the cutting blade.
The blades are marked with the diameter of the centre
hole.
Use only bushings supplied by Husqvarna. Those
bushings have been designed for your power cutter.
ASSEMBLING AND ADJUSTMENTS
Checking the direction of the
blade rotation
•
When using diamond blades make sure that it rotates
in the direction indicated by the arrow on the blade.
The direction of rotation for the machine is shown by
arrows on the cutting arm.
Fitting the cutting blade
•
The blade is placed on the bushing (A) between the
inner flange washer (B) and the flange washer (C).
The flange washer is turned so that it fits on the axle.
•
Lock the shaft. Insert a tool in the hole in the cutting
head and rotate the blade until it is locked.
•
Tightening torque for the bolt holding the blade is: 25
Nm (18,5 ft-Ibs).
–
English
13
Hide quick links:
Advertisement
Chapters
Table of Contents
