Table of Contents
Advertisement
Table 12. Filer installation process procedures
Stage
Procedure
1
Print and complete
a configuration
worksheet for each
system node of
your storage
system to gather
the information
that the software
setup process
requires.
2
Install the system
in a standard IBM
19-inch rack.
3
Connect the system
to the IP (Internet
Protocol) network.
Filer: Connect the
storage system to
storage expansion
units.
4
Gateway: Connect
the system to the
back-end storage.
5
Connect the system
to a power source.
6
Configure the
system.
7
Connect the system
to a third-party
device.
12
IBM System Storage: N6200 Series Hardware and Service Guide
Procedure is performed by...
Is the procedure
required?
Filer
Yes
Customer
Yes
Customer
Yes
Customer
Yes
Customer
Yes
n/a
Yes
Customer
Yes
Customer
No
Customer
Gateway
For instructions, see...
Customer
The configuration worksheet
is provided in the Data
ONTAP Software Setup Guide
for your version of Data
ONTAP.
IBM
The Installation and Setup
Instructions for your system
Customer
"Connecting your system to
an IP network" on page 13,
or the Installation and Setup
Instructions that came with
your system
n/a
"Connecting a filer to storage
expansion units" on page 15,
or the Installation and Setup
Instructions that came with
your system
Customer
Refer to the documentation
for your external storage for
additional information.
Customer
"Connecting your system to
a power source" on page 13,
or the Installation and Setup
Instructions that came with
your system
Customer
The Data ONTAP Software
Setup Guide for your version
of Data ONTAP, or the
Installation and Setup
Instructions that came with
your system
Customer
"Connecting your system to
storage" on page 15
Advertisement
Table of Contents
