3. TECHNICAL BRIEF 3. TECHNICAL BRIEF 3.1 GENERAL DESCRIPTION The KC910 supports UMTS-900, UMTS-2100, GSM-900, GSM-1800, and GSM-1900 based GSM/GPRS/EDGE/UMTS. All receivers and the UMTS transmitter use the radioOne Zero-IF architecture to eliminate intermediate frequencies, directly converting signals between RF and baseband.
2. The amplitude-modulated (AM) component is applied to the ramping control pin of Polar power amplifier from a DAC within the MSM KC910 power supply voltages are managed and regulated by the PM6658 Power Management IC. This versatile device integrates all wireless handset power management, general housekeeping, and user interface support functions into a single mixed signal IC.
3. TECHNICAL BRIEF 3.6 7 WLAN/Bluetooth/FM (WYSBNBGX6) The KC910 device provides the highest level of integration for a mobile wireless system, with integrated IEEE802. 11 b/g(MAC/baseband/radio), Bluetooth 2.0, and FM reveiver. The WYSBNBGX6 that is included of BCM4325 solution is supported three kinds of functions. It is the one antenna structure which is supported of WLAN/Bluetooth in 2.4GHz band.
3. TECHNICAL BRIEF Bluetooth The KC910 provides the Bluetooth 2.0 specification. The Bluetooth module is the optimal solution for any voice or data application that requires the Bluetooth SIG standard Host Controller Interface (HCI) using a high-speed UART and PCM. The Bluetooth solution has an integrated radio transceiver that has been optimized for 2.4GHz Bluetooth wireless systems.
EBI2 was targeted towards supporting slower asynchronous devices such as LCD, NAND flash, SRAM, etc. In addition, MSM6280 provide SD bus interface. KC910 supports 512MByte free user memory using SD interface. • EBI1 Features...
3. TECHNICAL BRIEF 3.11.5 Camera Interface KC910 Installed a 8M Pixel and 0.3Mega Camera. Below figure shows the camera board to board connector and camera I/F signal. CLOSE TO CONNECTOR FB600 5.6K R600 VGA_VDD_IO_2.7V VGA_VDD_2.7V 0.1u C611 CN601 SBIAS SSENS...
4. TROUBLE SHOOTING 4.8.1 USB trouble USB Initial sequence of KC910 is : USB connected to KC910 → USB_VBUS(D502) go to 5V → USB_D+(VA501) go to 3.3V → USB_DATA is triggered → USB work Start Cable inser t Cabl e is insert?
4. TROUBLE SHOOTING 4.8.2 UMS(USB MASS STORAGE) trouble UMS Initial sequence of KC910 is : USB connected to KC910 → VREG_5V(C501, UMS) go to 5V → VREG_USB_3.3V(C515) go to 3.3V → USB_DATA is triggered → USB work Start Cable inser t...
4.14 Camera trouble Camera control signals are generated by ZORAN (Multimedia Chip) and directly connected with ZORAN. KC910 has two cameras. The one is a 8 Mega Camera, the other is VGA camera. 8M START Check the ca mera conn. and...
5.1 Connecting to PC - Connect the KC910 phone to your desktop PC using the USB cable and run the LGMDP application. - Click on the Select Port and then Select Port window will be pop up. Check if state shows Enable for the port to be connected for downloading images.