Using The Cli To Configure Inverse Multiplexing; Adding And Configuring Connections On The Ausm/B - Cisco MGX 8850 Installation And Configuration Manual
Multiservice switch
Hide thumbs
Also See for MGX 8850:
- Command reference manual (786 pages) ,
- Product manual (62 pages) ,
- Installation and configuration manual (4 pages)
Table of Contents
Advertisement
ATM Universal Service Module
Using the CLI to Configure Inverse Multiplexing
The command sequence for configuring the IMA feature:
Step 1
Step 2
Step 3
Adding and Configuring Connections on the AUSM/B
You can add and modify connections through the Cisco WAN Manager or the CLI. Refer to
applicable documentation if you use the WAN Manager application. This section describes how to
add an ATM connection through the CLI according to the rules for adding a standard connection or
a management connection in the form of either a DAX con or a three-segment connection. See
"Rules for Adding Connections" earlier in this chapter.
6-14
Cisco MGX 8850 Installation and Configuration, Release 1.1.10, Part Number 78-6186-03
cnfportrscprtn <port_num> <controller> <ingress_%BW> <egress_%BW>
<number_of_cons> <VPImin/VPImax> [VCImin/VCImax]
•
port_num is the port number in the range 1–8.
•
controller is a number representing the controller: 1=PAR, 2=PNNI, and 3=MPLS.
•
ingress_%BW is the percentage of ingress bandwidth in the range 0–100.
•
egress_%BW is the percentage of egress bandwidth in the range 0–100.
•
number_of_cons is the maximum number of connections on the port.
•
VPImin/VPImax is the minimum and maximum VPI numbers.
•
VCImin/VCImax is the optional specification for VCI range.
addln on all constituent links.
cnfln if necessary.
addimagrp (or addaimgrp) to create the IMA group by using the following syntax:
addimagrp <group_num> <port_type> <list_of_links> <minNumLink>
group_num
is a number for IMA group. The range is 1–8.
port_type
is the port type: 1=UNI, 2=NN1.
list_of_links
is the list of links to be included in the group. Separate each link
number by a period.
minNumLink
is the minimum number of links in the range 1–8 to form a group.
For example: the following creates IMA group 1 with lines 3, 4, and 5. The minimum is 3.
addimagrp 1 3.4.5 3
IMA-related commands are dspimagrp, dspimagrpcnt, dspimagrps, dspimainfo, and
dspimalncnt. Refer to the Cisco MGX 8850 Wide Area Edge Switch Command Reference
for descriptions.
Advertisement
Table of Contents
