Table of Contents
Advertisement
Quickstart Provisioning Procedures
Command
Step 3
addport <options>
or
addimagrp <options>
addimalnk <options>
addimaport <options>
Related commands:
dspports
dspimalnk
dspimalnks
dspimagrp
dspimagrps
Step 4
addpart <options>
Related commands:
dspparts
dsppart
cnfpart
Step 5
dnpnport <portid>
Step 6
cnfpnportsig <options>
Related commands:
dsppnports
dsppnport <portid>
dsppnportsig <portid>
Step 7
cnfaddrreg <portid> no
addaddr <options>
Related commands:
dsppnports
dspatmaddr <portid>
deladdr <options>
Step 8
addprfx <portid> atm-prefix
Related commands:
cnfaddrreg <portid> yes
dspprfx <portid>
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-6
Chapter 3
Purpose
Add and configure ATM ports. This step establishes ATM layer
two communications between two ATM devices.
Note
The PNNI or MPLS controller must be added before
adding UNI ports. Procedures for adding controllers can
be found in
Chapter 2, "Configuring General Switch
Features."
Specify UNI for ATM lines.
For standard port configuration, see the
section later in this chapter.
If you want to configure ATM communications over an IMA
group, see the
"Configuring Inverse Multiplexing for
section later in this chapter.
Assign line resources to the PNNI controllers. This step can
assign all the line bandwidth to a single controller, or it can assign
portions of the line bandwidth to each controller.
See the
"Partitioning Port Resources Between
section later in this chapter.
Bring down the port so it can be configured. The next three steps
require this step.
Define the signaling protocol used on the line. The default
signaling protocol for UNI lines is UNI none.
Specify uni30, uni31, or uni40.
See the
"Selecting the Port Signaling
this chapter.
If required, configure static ATM addresses for the PXM1E UNI
port.
See the
"Assigning Static ATM Addresses to Destination
section later in this chapter.
If dynamic addressing is to be used on a port, define an ATM
address prefix that ILMI can use when assigning addresses.
See the
"Configuring ILMI Dynamic
this chapter.
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Provisioning PXM1E Communication Links
"Adding ATM
Ports"
ATM"
Controllers"
Protocol" section later in
Addressing" section later in
Ports"
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco MGX 8850 (PXM1E/PXM45)
Related Products for Cisco MGX 8850 (PXM1E/PXM45)
- Cisco 887V - Integrated Services Router
- Cisco 880 Series
- Cisco 881-SEC-K9 - 881 Ethernet Security Router
- Cisco 881G-K9 - 881 EN Security Router
- Cisco 886G-K9 - 886 ADSL2/2+ Annex B Router
- Cisco Cisco 881
- Cisco 881G-G-K9 - 881 Fast EN Security Router Wireless
- Cisco 888GW-GN-E-K9 - 888 G.SHDSL Wireless Router