Configuring The Ethernet Management Interface - Cisco ASR 5500 Installation Manual
Hide thumbs
Also See for ASR 5500:
- System administration manual (430 pages) ,
- Administration manual (410 pages) ,
- Installation manual (174 pages)
Table of Contents
Advertisement
Configuring the Ethernet Management Interface
Configuring the Ethernet Management Interface
The procedure below describes how to configure an Ethernet management interface on the primary MIO/UMIO
in slot 5.
Important
Step 1
Enter config to enter the configuration mode.
[local]host_name#
Step 2
Enter context local to enter the context configuration mode. The following prompt appears:
[local]host_name(config)#
[local]host_name(config-ctx)#
Step 3
Enter interface interface_name to specify a name for the interface. interface_name is the name of the interface. The
interface name can be between 1 and 79 alphanumeric characters and is case sensitive. The following prompt appears
as the system enters the Ethernet Interface Configuration mode:
[local]host_name(config-ctx)#
[local]host_name(config-if-eth)#
Step 4
Configure the IP address for the interface.
• For IPv4: Configure an IP address for the interface configured in the previous step by entering ip address ipaddress
subnetmask. ip_address specifies the IP address for the interface in dotted-decimal format. subnetmask specifies
the subnet mask for the interface in dotted-decimal or CIDR format.
• For IPv6: Configure an IP address for the interface configured in the previous step by entering ipv6 address
ipv6address subnetmask. ipv6address specifies the IP address for the interface in colon-separated-hexadecimal
format. subnetmask specifies the subnet mask for the interface in colon-separated-hexadecimal or CDIR format.
For example:
[local]host_name(config-if-eth)#
[local]host_name(config-if-eth)#
Step 5
Enter exit to exit the Ethernet interface configuration mode. The following prompt appears:
[local]host_name(config-ctx)#
Step 6
If necessary, configure a static route to point the system to a default gateway by entering the following command: { ip
| ipv6 } route gw_address interface_name. gw_address specifies the IP address of the default gateway in IPv4
dotted-decimal format or IPv6 colon-separated-hexadecimal format). interface_name specifies the name of the interface
that was configured in Step 2. Refer to the System Administration Guide for additional information.
Step 7
Enter exit at the prompt to exit the context configuration mode. The following prompt appears:
[local]host_name(config-ctx)#
[local]host_name(config)#
ASR 5500 Installation Guide
102
Repeat the procedure below to configure the second Ethernet management interface on the MIO/UMIO
in slot 5.
config
context local
interface local01
ip address 10.0.153.100 255.255.255.248
ipv6 address 2620:0:60:48::10/64
exit
Initial System Configuration
Advertisement
Table of Contents
