Table of Contents
Advertisement
Configuring Fibre Channel Interfaces
Configuring Fibre Channel Interfaces
Configuring a Fibre Channel Interface
To configure a Fibre Channel interface, perform this task:
Procedure
Step 1
Step 2
Configuring a Range of Fibre Channel Interfaces
To configure a range of Fibre Channel interfaces, perform this task:
Procedure
Step 1
Step 2
Setting the Interface Administrative State
To gracefully shut down an interface, perform this task:
To enable traffic flow, perform this task:
OL-30895-01
Command or Action
switch# configuration terminal
switch(config)# interface {fc
slot/port}|{vfc vfc-id}
Command or Action
switch# configuration terminal
switch(config)# interface { fc slot/port -
port [ , fc slot/port - port ] | vfc vfc-id - vfc-id
[ , vfc vfc-id - vfc-id ] }
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
Configuring Fibre Channel Interfaces
Purpose
Enters configuration mode.
Selects a Fibre Channel interface and enters interface
configuration mode.
Note
When a Fibre Channel interface is configured, it is
automatically assigned a unique world wide name
(WWN). If the interface's operational state is up, it is
also assigned a Fibre Channel ID (FC ID).
If this is a QSFP+ GEM, the slot/port syntax is
Note
slot/QSFP-module/port.
Purpose
Enters configuration mode.
Selects the range of Fibre Channel interfaces and
enters interface configuration mode.
If this is a QSFP+ GEM, the slot/port
Note
syntax is slot/QSFP-module/port.
15
Advertisement
Table of Contents
