Cisco Catalyst 3560 Hardware Installation Manual page 37
Hide thumbs
Also See for Catalyst 3560:
- Getting started manual (37 pages) ,
- Software configuration manual (892 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 1
Using Express Setup
Follow these steps to start the Express Setup program:
Verify that no devices are connected to the switch.
Step 1
Press and hold the Mode button, as shown in
Step 2
Mode button turn green. This takes approximately 3 seconds.
Figure 1-4
M O D E
1 Mode button
Release the Mode button.
Step 3
Note
If all of the LEDs begin to blink after you press the Mode button, release it.
Blinking LEDs mean that the switch has already been configured and cannot go
into Express Setup mode. For more information, see the
Address and Configuration" section on page
78-16057-01
Starting Express Setup
1
2
3
4
1 X
S Y S T
R P S
S T A T
D U P L X
S P E E D
P o E
2 X
1
Figure
5
6
7
8
9
1 0
4-2.
Catalyst 3560 Switch Hardware Installation Guide
Starting Express Setup
1-4, until the LEDs above the
1 1
1 2
1 3
1 4
1 5
1 6
1 5 X
1 6 X
"Clearing the Switch IP
1-5
Advertisement
Table of Contents
