Where To Go Next - Cisco Catalyst 3560 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 3560:
- Getting started manual (37 pages) ,
- Software configuration manual (892 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 3
Switch Installation
Step 4
Where to Go Next
78-16057-01
The LED turns green when the switch and the target device have an established
link.
The LED turns amber while the STP discovers the network topology and searches
for loops. This process takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable
problem, or there might be problem with the adapter installed in the target device.
See
Chapter 4, "Troubleshooting,"
If necessary, reconfigure and restart the switch or target device.
If the default configuration is satisfactory, the switch does not need further
configuration. You can use any of these management options to change the default
configuration:
Start CMS, as described in the switch software configuration guide, and
•
configure the switch as a member of a cluster or as an individual switch. Refer
to the Release Notes for the Catalyst 3560 Switch on Cisco.com for the most
current browser requirements.
Use the CLI from the console to configure the switch as a member of a cluster
•
or as an individual switch. Refer to the Catalyst 3560 Switch Software
Configuration Guide and the Catalyst 3560 Switch Command Reference on
Cisco.com for information on using the CLI with a Catalyst 3560 switch.
For setup instructions that use the CLI setup program, go to
"Configuring the Switch with the CLI-Based Setup Program."
Start an SNMP application such as the CiscoView application.
•
for solutions to cabling problems.
Catalyst 3560 Switch Hardware Installation Guide
Where to Go Next
Appendix C,
3-35
Advertisement
Table of Contents
