Monitoring Ip Source Guard - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
Command or Action
Step 6
switchport access vlan vlan-id
Example:
Switch(config-if)# switchport access vlan
10
Step 7
ip verify source[tracking] [mac-check ]
Example:
Switch(config-if)# ip verify source tracking
mac-check
Step 8
ip device tracking maximum number
Example:
Switch(config-if)# ip device tracking
maximum 8
Step 9
end
Example:
Switch(config)# end
Monitoring IP Source Guard
Table 121: Privileged EXEC show Commands
Command
show ip verify source [ interface interface-id ]
show ip device tracking { all | interface interface-id
| ip ip-address | mac imac-address}
Table 122: Interface Configuration Commands
Command
ip verify source tracking
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Purpose
Configures the VLAN for this port.
Enables IP source guard with source IP address filtering.
(Optional) tracking—Enables IP source guard for static hosts.
(Optional) mac-check—Enables MAC address filtering.
The command ip verify source tracking mac-checkenables IP
source guard for static hosts with MAC address filtering.
Establishes a maximum limit for the number of static IPs that
the IP device tracking table allows on the port. The range is 1to
10. The maximum number is 10.
You must configure the ip device tracking maximum
Note
limit-number interface configuration command.
Returns to privileged EXEC mode.
Purpose
Displays the IP source guard configuration on the
switch or on a specific interface.
Displays information about the entries in the IP device
tracking table.
Purpose
Verifies the data source.
Monitoring IP Source Guard
1297
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
