Specifying Foreach Iterating Statements - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
How to Write EEM Policies Using the Cisco IOS CLI
Command or Action
Example:
Device(config-applet)# action 2.0 if $x lt 10
Step 6
Add any action as required.
Example:
Device(config-applet)# action 3.0 puts "$x is
less than 10"
Step 7
action label else
Example:
Device(config-applet)# action 4.0 else
Step 8
Add any action as required.
Example:
Device(config-applet)# action 5.0
Step 9
end
Example:
Device(config-applet)# end
Specifying foreach Iterating Statements
To specify a conditional statement that iterates over an input string using the delimiter as a tokenizing pattern,
perform this task. The foreach iteration statement is used to iterate through a collection to get the desired
information. The delimiter is a regular expression pattern string. The token found in each iteration is assigned
to the given iterator variable. All arithmetic calculations are performed as long integers with out any checks
for overflow. In this task, the value of the variable x is set to 5. An iteration statement is set to run through
the input string red, blue, green, orange. For every element in the input string, a corresponding message is
displayed on the screen.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1736
Purpose
Performs the action as indicated by the action command.
• In this example, the message '5 is less than 10' is
displayed on the screen.
Specifies an else conditional statement
Performs the action as indicated by the action command.
• In this example, the message '5 is greater than 10' is
displayed on the screen.
Exits from the running action.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
