Configuration Examples For Vlan Trunking - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
Configuration Examples for VLAN Trunking
Command or Action
30
Step 13
end
Example:
Switch(config-if)# end
Step 14
Repeat Steps 9 through 13 on the other configured trunk
interface on Switch A, and set the spanning-tree path
cost to 30 for VLANs 8, 9, and 10.
Step 15
exit
Example:
Switch(config)# exit
Step 16
show running-config
Example:
Switch# show running-config
Step 17
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Related Topics
Network Load Sharing Using STP Path Cost, on page 2132
Configuration Examples for VLAN Trunking
Example: Configuring a Trunk Port
The following example shows how to configure a port as an IEEE 802.1Q trunk. The example assumes that
the neighbor interface is configured to support IEEE 802.1Q trunking.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# switchport mode dynamic desirable
Switch(config-if)# end
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2148
Purpose
Returns to global configuration mode.
Returns to privileged EXEC mode.
Verifies your entries. In the display, verify that the path
costs are set correctly for both trunk interfaces.
(Optional) Saves your entries in the configuration file.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
