Table of Contents
Advertisement
Using Interface Configuration Mode
Enter the show interfaces privileged EXEC command to see a list of all interfaces on or configured for
the switch. A report is provided for each interface that the device supports or for the specified interface.
Configuring a Range of Interfaces
You can use the interface range global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface-range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
Command
Step 1
configure terminal
Step 2
interface range {port-range | macro
macro_name}
Step 3
Step 4
end
Step 5
show interfaces [interface-id]
Step 6
copy running-config startup-config
When using the interface range global configuration command, note these guidelines:
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
11-10
Valid entries for port-range:
vlan vlan-ID - vlan-ID, where the VLAN ID is 1 to 4094
–
gigabitethernet module/{first port} - {last port}, where the module is always 0 (for
–
nonstacking-capable switches)
gigabitethernet stack member/module/{first port} - {last port}, where the module is always 0
(for stacking-capable switches)
tengigabitethernet module/{first port} - {last port}, where the module is always 0 (for
–
nonstacking-capable switches)
tengigabitethernet stack member/module/{first port} - {last port}, where the module is always
0 (for stacking-capable switches)
port-channel port-channel-number - port-channel-number, where the port-channel-number
–
is 1 to 64
Purpose
Enter global configuration mode.
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface-range configuration mode.
You can use the interface range command to configure up to five
•
port ranges or a previously defined macro.
The macro variable is explained in the
•
Interface Range Macros" section on page
In a comma-separated port-range, you must enter the interface
•
type for each entry and enter spaces before and after the comma.
In a hyphen-separated port-range, you do not need to re-enter the
•
interface type, but you must enter a space before the hyphen.
Use the normal configuration commands to apply the configuration
parameters to all interfaces in the range. Each command is executed
as it is entered.
Return to privileged EXEC mode.
Verify the configuration of the interfaces in the range.
(Optional) Save your entries in the configuration file.
Chapter 11
Configuring Interface Characteristics
"Configuring and Using
11-11.
OL-12247-04
Advertisement
Chapters
Table of Contents
Troubleshooting
