hit counter script

Understanding The Show Switch Stack-Ports Summary Output - Cisco 3032 Software Configuration Manual

Hide thumbs Also See for 3032:
Table of Contents

Advertisement

Chapter 5
Managing Switch Stacks

Understanding the show switch stack-ports summary Output

Only Port 1 on stack member 2 is disabled.
Switch# show switch stack-ports summary
Switch#/
Port#
--------
1/1
1/2
2/1
2/2
3/1
3/2
Table 5-5
Field
Switch#/Port#
Stack Port Status
Neighbor
Cable Length
Link OK
Link Active
Sync OK
# Changes to LinkOK
In Loopback
OL-12247-04
Stack
Neighbor
Cable
Port
Length
Status
------
--------
--------
OK
3
50 cm
Down
None
3 m
Down
None
3 m
OK
3
50 cm
OK
2
50 cm
OK
1
50 cm
show switch stack-ports summary Command Output
Description
Member number and its stack port number.
Absent—No cable is detected on the stack port.
Down—A cable is detected, but either no connected neighbor is up,
or the stack port is disabled.
OK—A cable is detected, and the connected neighbor is up.
Switch number of the active member at the other end of the stack cable.
Valid lengths are 50 cm, 1 m, or 3 m.
If the switch cannot detect the cable length, the value is no cable. The
cable might not be connected, or the link might be unreliable.
This shows if the link is stable.
The link partner is a stack port on a neighbor switch.
No—The link partner receives invalid protocol messages from the
port.
Yes—The link partner receives valid protocol messages from the
port.
This shows if the stack port is in the same state as its link partner.
No—The port cannot send traffic to the link partner.
Yes—The port can send traffic to the link partner.
No—The link partner does not send valid protocol messages to the
stack port.
Yes—The link partner sends valid protocol messages to the port.
This shows the relative stability of the link.
If a large number of changes occur in a short period of time, link flapping
can occur.
No—At least one stack port on the member has an attached stack
cable.
Yes—None of the stack ports on the member has an attached stack
cable.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Link
Link
Sync
OK
Active
OK
Changes
To LinkOK
----
------
----
---------
Yes
Yes
Yes
Yes
No
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Troubleshooting Stacks
#
In
Loopback
--------
1
No
1
No
1
No
1
No
1
No
1
No
5-29

Advertisement

Table of Contents
loading

This manual is also suitable for:

3130

Table of Contents