Resetting The Switch; How To Recover Passwords; Finding The Switch Serial Number - Cisco IE 4010 Hardware Installation Manual

Hide thumbs Also See for IE 4010:

Table of Contents

Troubleshooting

Resetting the Switch

These are reasons why you might want to reset the switch to the factory default settings:



You installed the switch in your network and cannot connect to it because you assigned the wrong IP address.



You want to reset the password on the switch.

Note:

Resetting the switch deletes the configuration and reboots the switch.

Caution:

If you press the Express Setup button when you power on, the automatic boot sequence stops, and the

switch enters bootloader mode.

To reset the switch:

Press and hold the Express Setup button (recessed behind a small hole in the faceplate) for about 10 seconds with

a paper clip or similar object. The switch reboots. The system LED turns green after the switch completes rebooting.

Press the Express Setup button again for 3 seconds. A switch 10/100/1000 Ethernet port blinks green.

The switch now behaves like an unconfigured switch. You can configure the switch by using the CLI setup procedure

described in

Configuring the Switch with the CLI Setup Program, page 57

Password recovery is a feature that a system administrator can enable or disable. If password recovery is disabled, the

only way to recover from a lost or forgotten password is to clear the switch configuration entirely. For this procedure, see

the

How to Recover Passwords, page

The Cisco IE 4010 Switch Software Configuration Guide provides details about enabling and disabling the password

recovery feature and the procedure for recovering passwords.

If you contact Cisco Technical Assistance, you need to know the serial number of your switch. The serial number is on

the top of the switch. You can also use the show version command to obtain the switch serial number.

48.

Table of Contents

Show Quick Links

Table of Contents