Entering The Initial Configuration Information; Completing The Setup Program - Cisco IE 4010 Hardware Installation Manual
Hide thumbs
Also See for IE 4010:
- Software configuration manual (1066 pages) ,
- Product documentation (28 pages) ,
- Hardware installation manual (86 pages)
Table of Contents
Advertisement
Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
2.
Click Next.
3.
When the InstallShield Wizard for Cisco Virtual Com appears, click Next.
4.
When the Program Maintenance window appears, select the Remove radio button.
5.
Click Next.
6.
When the Remove the Program window appears, click Remove.
If a User Account Control warning appears, click Allow - I trust this program to proceed.
7.
When the InstallShield Wizard Completed window appears, click Finish.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch powers on. You
must assign an IP address and other configuration information necessary for the switch to communicate with the local
routers and the Internet.
IP Settings
You need this information:
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Completing the Setup Program
Follow these steps to complete the setup program and to create an initial configuration for the switch:
1.
Enter Yes at these two prompts.
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
2.
Enter a host name for the switch, and press Return.
65
Hide quick links:
Advertisement
Table of Contents
