About the Quick Reference Manual This Quick Reference Manual explains the connections and basic operations of this unit, and gives notes on operations and information required for maintenance. For details on the operations or safety precautions, refer to the Operating Instructions.
Notes on Use Note on the Ventilation Holes Do not block ventilation holes (exhaust/intake). If they are blocked, internal heat may build up and cause fire or damage to the unit. Check the positions of the ventilation holes shown in the following illustrations. For other precautions, read the separate Operating Instructions carefully.
Projecting Connecting the Projector When you connect the projector, make sure to: • Turn off all equipment before making any connections. • Use the proper cables for each connection. • Insert the cable plugs firmly. When pulling out a cable, be sure to pull it out from the plug, not the cable itself.
Page 5
To connect a computer (Digital) or video equipment (Digital) (VPL-EW5 only) a Plug the AC power cord into a wall outlet. b Connect the projector to a computer or video equipment. VPL-EW5 HDMI-DVI-D cable (not supplied) HDMI cable (not supplied) Notes •...
Page 6
To connect a VCR/DVD player a Plug the AC power cord into a wall outlet. b Connect the projector to a video equipment. For video signal connections, the following three connecting options are available: 1 S video (Mini DIN 4-pin) cable (not supplied) 2 Composite video (phono) cable (not supplied) ×...
Page 7
Projecting Note EX5U does not have the Control panel keys. Use the Remote Commander for all operations. a Press the I/ (on/standby) key. b Turn on the equipment connected to the projector. c Press the INPUT key on the Remote Commander or the control panel to select the input source.
Adjusting the Projector a Adjust the position of the picture. b Adjust the size of the picture. c Adjust the focus. The projector is equipped with the Picture menu to select the picture mode, and the Screen menu to select the appropriate aspect ratio of the picture. Turning off the Power Note EX5U does not have the Control panel keys.
(a). Fold out the handle (b), then Notes pull out the lamp unit by the handle (c). • If the lamp breaks, ask qualified Sony personnel to replace the lamp and to check inside. • Pull out the lamp by holding the handle.
Page 10
Insert the new lamp all the way in until SET SETTING Input-A it is securely in place (a). Tighten the S m a r t A PA : two screws (b). Fold down the Auto Input Search: O f f Input-A Signal Sel.: Au t o handle to replace it (c).
Cleaning the Air Notes • If you neglect to clean the air filter, dust Filter may accumulate, clogging it. As a result, the temperature may rise inside the unit, leading to a possible malfunction or fire. The air filter should be cleaned whenever •...
If the projector appears to be operating erratically, try to diagnose and correct the problem using the following instructions. If the problem persists, consult with qualified Sony personnel. For details on the symptoms, see the Operating Instructions contained in the CD- ROM.
Page 13
Ensure that “High Altitude Mode” in the Setup menu is set to “On.” key flashes in red. The fan is broken. (Repetition rate of 4 Consult with qualified Sony personnel. flashes) key flashes in red. Unplug the AC power cord from the wall outlet after the (Repetition rate of 6...
There may be a slight difference between the 3 LCD panels, 1 lens, 3 primary actual value and the design value shown above. color shutter system LCD panel VPL-ES5: 0.63-inch SVGA panel, Color system NTSC /PAL/SECAM/ 3.58 about 1,440,000 pixels (800 ×...
Design and specifications are subject to change without notice. Note Always verify that the unit is operating properly before use. SONY WILL NOT BE LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO, COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF THE...
Page 16
Halogenated flame retardants are not used in cabinets and printed wiring boards. Sony Corporation Printed in China...