Advertisement
Table of Contents
- 1 Quick Start
- 1 Chapter 1: Safety Precautions
- 2 Chapter 2: Introduction
- 3 Chapter 3: Overview
- 4 Chapter 4. Connecting the Residential Voip Cable Modem to Your Computer
- 5 Chapter 5. Web Configuration
- 6 Chapter 6. Technical Specification
- 7 Chapter 7. Wireless SSID and WPA Pre-Shared Key
- Download this manual
Advertisement
Table of Contents
Related Manuals for Huawei CG1241
Summary of Contents for Huawei CG1241
-
Page 1: Quick Start
CG1241/CG1241D Cable Modem Quick Start... -
Page 2: Chapter 1: Safety Precautions
Chapter 1: Safety Precautions To use the device properly and safely, read the safety precautions carefully before using the device and strictly observe these precautions when using the device. Safety precautions: Keep the device out of the reach of children as the components or accessories may be swallowed. Install the device in strict compliance with the requirements of the supplier. -
Page 3: Chapter 2: Introduction
Chapter 2: Introduction CG1241/CG1241D is a residential VoIP cable modem which has an 802.11bgn WiFi access point that gives you wireless connection to the Internet with 4 Giga Ethernet ports which further expand the Local Area Network (LAN) capabilities. CG1241D provides additional 802.11 WiFi interface supports 802.11A/N capability. -
Page 4: Chapter 3: Overview
Chapter 3: Overview Front Panel The following illustration shows the front panel of the EMTA: Power - Indicates the Power status. DS - Indicates the status of Data reception by the cable modem from the Network (Downstream Traffic). US - Indicates the status of Data transmission by the cable modem to the Network (Upstream Traffic). Online - Displays the status of your cable connection. - Page 5 There will be 12 LEDs on CG1241/CG1241D Looking at LED from TOP to Bottom: Power, DS, US, Online, LAN1, LAN2, LAN3, LAN4, WiFi, PHONE1, PHONE2, WPS. Internet CG1241/CG1241D Power Wi-Fi Phone1 Phone2 WPS Description Online Power on 0.25 sec 0.25 second...
- Page 6 Rear Panel Connector Description Slot Description CABLE F-Connector RESET Reset/Reboot this Cable modem ETHERNET 1 2 3 4 Ethernet 10/100/1000 BaseT RJ-45 connector TEL 1 2 Telephony RJ-11 connector 12VDC 12V DC-IN Power connector DC Power switch Power ON/OFF switch...
- Page 7 WPS – Indicates the status of the WPS (Wi-Fi Protected Setup ) functionality. There is one WPS button on the Top Side Panel of CG1241/CG1241D and is designed to have multiple function. This button can be used to: Securely and Simply Get WiFi Client Connected: WPS button can be used to paring WiFi client which also supports WPS function.
-
Page 8: Chapter 4. Connecting The Residential Voip Cable Modem To Your Computer
2. Connect one end of the coaxial cable to the CABLE connection on the wall, and the other end to the CABLE jack on the CG1241/CG1241D. 3. Connect the plug from the power supply into the POWER jack on the CG1241/CG1241D, and plug the power supply into an AC outlet. -
Page 9: Chapter 5. Web Configuration
Chapter 5. WEB Configuration If enabled by your service provider; please proceed as follows: Once your host PC is properly configured. Start your web browser and type the private IP address of the EMTA on the URL field: 192.168.1.1. After connecting to the URL, you can see the login page. Please enter the username, password and then press Login button. -
Page 10: Chapter 6. Technical Specification
Chapter 6. Technical Specification 1. Power Requirements : Power adaptor requirement : Input: 100V~240VAC±10% Output: 12VDC 2A Plug Type: Two round pins Frequency: 50-60 Hz±10% Power Consumption : 24W DC voltage tolerance : 11.4V~12.6V Power requirement : on/off DC power switch on housing 2. -
Page 11: Chapter 7. Wireless Ssid And Wpa Pre-Shared Key
Chapter 7. Wireless SSID and WPA Pre-shared Key Default SSID and WPA Pre-shared Key on the CM Lable. Note: If you want to change your SSID and WPA Pre-shared Key, please connect webpage. Fig. primary Network configuration... - Page 12 CAUTION for UL North American Cable Installer: This reminder is provided to call your attention to Article 820.93 of the National Electrical Code (Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.
-
Page 13: Warranty Card
Warranty Card Thank you for choosing Huawei Technologies Co., Ltd. To get better services, please read this warranty card carefully, fill in the required information, and preserve this card in good condition. PERSONAL OR COMPANY FULL NAME Address/Postal Code Telephone Number... -
Page 14: Limited Warranty
In any case that is not covered by this limited warranty or should the warranty expire, Huawei shall charge for the service(s) claimed for the products if the product is still remediable. Huawei preserves the right for interpretation of this limited warranty. - Page 15 No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice.
- Page 16 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 17 Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model.