hit counter script

Changing A Cable Modem Service Class - Cisco cBR 8 Configuration Manual

Cbr series converged broadband routers
Table of Contents

Advertisement

Subscriber Traffic Management
Step 2
Step 3
Step 4

Changing a Cable Modem Service Class

Use the following procedure to change a QoS service class for a particular DOCSIS 1.1 cable modem.
Restriction
Procedure
Step 1
Command or Action
configure terminal
Example:
Router# configure terminal
no cable qos enforce-rulename
Example:
Router(config)# no cable qos
enforce-rule ef-rule
end
Example:
Router(config)# end
• The command is supported only on DOCSIS 1.1 CM primary service flows.
• You can specify the cable modem service-class-name command only after the CM has been online
for at least 200 seconds.
• The parameters defined by the named service class should always be a compatible subset of the
registered set of parameters for the CM. Only certain options can be changed using a CMTS router
service class, such as the max-rate, priority, or tos-overwrite options. The max-burst option in
both the enforced and registered CMTS router service classes must strictly match the value for
max-burst in the registered DOCSIS configuration file. If the service class value does not match,
then CM registration will fail with a reject-c state, or the enforced class will fail.
Command or Action
enable
Example:
Router> enable
Cisco cBR Series Converged Broadband Routers Quality of Services Configuration Guide for Cisco IOS XE Fuji
Changing a Cable Modem Service Class
Purpose
Enters global configuration mode.
Deletes the enforce-rule with the specified name . This
enforce-rule and its configuration are removed from
the CMTS configuration, and any subscriber traffic
management that uses this rule ends.
Exits global configuration mode and returns to
privileged EXEC mode.
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
16.7.x
135

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents